/**
  @page IO_Toggle Binary   Description of the IO_Toggle example firmware's binary files

  @verbatim
  ******************** (C) COPYRIGHT 2014 STMicroelectronics *******************
  * @file    readme.txt 
  * @author  MCD Application Team
  * @version V1.2.0
  * @date    11-April-2014
  * @brief   Description of the IO_Toggle example firmware's binary files.
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT 2014 STMicroelectronics</center></h2>
  *
  *
  * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
  * You may not use this file except in compliance with the License.
  * You may obtain a copy of the License at:
  *
  *        http://www.st.com/software_license_agreement_liberty_v2
  *
  * Unless required by applicable law or agreed to in writing, software 
  * distributed under the License is distributed on an "AS IS" BASIS, 
  * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
  * See the License for the specific language governing permissions and
  * limitations under the License.
  *
  ******************************************************************************
  @endverbatim


@par Description

This directory contains binary file (*.hex) of the IO_Toggle example firmware V1.2.0
 customized to run on STM32F10x devices.
 
You can use any in-system programming tool to reprogram the demonstration using
this binary file, as described below:

  - Connect the STM32NUCLEO board to a PC with a 'USB type A to Mini-B'
    cable through USB connector CN1 to power the board.
  - Make sure that the embedded ST-LINK/V2 is configured for in-system programming
    (both CN2 jumpers ON)
  - Use the *.hex binary with your preferred in-system programming tool to reprogram
    the demonstration firmware (ex. STM32 ST-LINK Utility, available for download from www.st.com).
 
 * <h3><center>&copy; COPYRIGHT STMicroelectronics</center></h3>
 */
